Shenzhen Genyongjian Electronics Co., Ltd. is a professional production of silicone products. 15 years of professional production of silicone keypad, conductive tape, silicone rubber products. All silicone products in the production of die before they have to do first, through the mold to develop new products.
Sample module, also known as hand model. When customers want to confirm with us when we play the sample, we first need to provide a model or 2D, or 3D map. If the customer is the model, we obtained under the model to the 3D map scanner. If the customer is the 3D map, it is more convenient, we will die housing master plans based on customer provided to program 3D mold. Kind of mold is usually the first open confirmation sampling to customers, and then when the customer confirmed that no problem to open a large-scale production.
Sample mode to open a general point to 2 points, when the sample should be much more, our model will also open four point samples. Sample mode to play a kind of role in early recognition, it will become a real image file. Because silicone flexible, so the products produced on the physical and drawings are not necessarily completely consistent, this time we have only to open the first sample mode, play samples out to customers to confirm. If a sample mold problems, mold is also relatively simple changes at this time, modify time is short, and high efficiency. Each mold, mold repair must be to confirm through proofing products, which is confirmed mold. When the products developed are in line with the requirements of the guests, and then the mold was also confirmed.
Samples of raw materials module
Samples of our model are made with steel. According to the size of the product to determine the size of the template.
Production time of the sample model
The length of the sample pattern making structures by the complexity of the product decisions. Usually relatively simple program to process the completion of general from about 2-3 days on; complex is probably to be 5-7 days. The more complex product mix, the longer the mold.
The benefits of opening of a sample module
First of all, the point sample mode to open a few of the template to use less processing time is short, the costs would be relatively small, the efficiency will be high. Second, the opening of a sample module will also bring other benefits, such as product mix for the first time even if not confirmed, modified mold is also more convenient, the revised proofs can be confirmed immediately, thus shortening the time. Third, because the cost is low, so the first opening of a sample mold can reduce the risk. If you directly open a large-scale, can not confirm the first sample, after the mold with a modified product will bring a lot of quality problems, the more this case Moju only more bad repair, the more the more is not conducive to production of repair. So open a sample model can achieve the first objective confirmation of products, confirmed no problem, once a good job on a large-scale, this produced very little product quality problems.
|
News